Zeez F7 3030 V3 Flight Controller

Description

About this product
The ZEEZ F7 V3 3030 is an 8 Motor Output, DJI HD System Ready Flight Controller with an on-board 9V@3A regulator to power the DJI Air Unit, with a simple plug-and-play configuration and 5V@3A regulator to power all the peripheral.
It uses a powerful F7 processor along with top-of-the-line hardware: ICM42688P Gyro, BMP388 Barometer, with a separate power rail for cleanest data. The ZEEZ F7 V3 3030 comes in a standard 30×30 form factor. It comes with spaces and pads for TBS Crossfire and TBS Unify Nano32 for a very clean and low-profile assembly. Zeez have added a connector for a 2nd ESC to make building X8s as easy as possible. There are 5 UARTS available as well as an I2C port, SD CARD for Blackbox data record, and an OSD chip for analog video.
Note: (Insert any product notes here in Red BOLD Italic . Example: “First Shipment expected January 2022” or “Electronics are Not Included”.)
VIDEO: (Insert Video Title here in Bold )
Features
8 Motor Output
Uses a powerful F7 processor along with top-of-the-line hardware
Comes with spaces and pads for TBS Crossfire and TBS Unify Nano32
5 UARTS available
DJI HD System Read
USE BULLETED FEATURE HERE IN BOLD CAPS.
Add additional feature descriptions here to describe the above.
USE BULLETED FEATURE HERE IN BOLD CAPS.
Add additional feature descriptions here to describe the above.
Specifications
Mounting holes: 30.5×30.5mm
LiPo Power input: 3S-6S
8 Motor output
BEC 5V-3A / 9V-3A
STM32F722 MCU (216MHz max frequency)
ICM42688P Gyro/ACC
BMP388 Barometer
OSD chip Onboard
5 available UARTs / I2C bus
SD Card Reader
HD Plug for DJI Air Unit or Caddx Vista or Walksnail VTX
USB Type C connector
Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation
IMPORTANT NOTES
Insert important warnings or notes here. Example: “Do not overheat.” or “Always use the included charger for best performance.”
Recommended (Not Included)
(Insert recommended products here. Example: “Battery: Lumenier 10000mAh 6s 25c Lipo Battery “)
Links
Download Wiring Diagram
Includes
1x Zeez RC F7 3030 Flight Controller V3
4x Aluminum Standoff
4x Aluminum Nut
1x ESC to Flight Controller 8 Pin to 8 Pin JST SH 1mm Connector
1x ESC to Flight Controller 8 Pin to Free Wires (with JST SH crimp)
1x 2nd ESC to Flight Controller 5 Pin to 8 Pin JST SH 1mm connector
1x 2nd ESC to Flight Controller 5 Pin to Free Wires (with JST SH crimp)
1x JST SH 8 Pin Plastic Housing
1x JST SH 10 Pin Plastic Housing
2x 2.00mm Header Pin for VTX Connection
2x 2.54mm Header Pin for Receiver Connection
1x JST 6 pin to AirUnit Connector
Featured Videos
ADD VIDEO TITLE HERE IN BOLD CAPS
ADD VIDEO TITLE HERE IN BOLD CAPS