Asked by: Konimba Hervy
asked in category: General Last Updated: 9th May, 2020

Can you cut commercial electric LED tape light?

The Commercial Electric 24 ft. LED Flexible Indoor/Outdoor Rated Bright White Tape Light works where other lighting cannot. 3M adhesive tape backing and mounting clips make installation as easy as peel-and-stick and will attach to just about any surface. Can be cut to desired length and reconnected.

Click to see full answer.

Keeping this in consideration, can I cut LED Strip Lights?

LED Strip Lights can be cut at 5 or 10 cm intervals, depending on the type of strip light purchased. The "cutting points" are clearly marked with a straight line. To seperate your strip lights, cut along the line using a pair of scissors or craft knife.

Beside above, how many times can you cut LED Strip Lights? The cutting intervals are as follows: 30 LEDs per metre can be cut every 10cm, 60 LEDs per metre can be cut every 5cm, and.

Also, how do you fix LED strip lights when cutting?

When cutting LED Strip Light it is very important to cut only on the given cut line between the copper dots. Cutting through or before the copper dots will result in no electrical conductivity to the following section. Use a pair of sharp scissors to cut the LED Strip Light directly down the given cut line.

Can you connect LED light strips together?

The copper solder pads make it so each strip piece is addressable even after being cut. This makes it possible to connect LED strips together or connect the strip in a different area of your home. 12 volt LED lights – The LED strip lights need 12VDC power input to run.

34 Related Question Answers Found

How do you power a 12v LED strip with a battery?

How do you make homemade colored LED strip lights?

How do I reset my LED strip light?

What is the difference between 3528 and 5050 led?

Do LED strip lights need a transformer?